Ublox NORA-W36 Series, System Integration Manual

Page: 27 / 48

NORA-W36 series - System integration manual
UBX-22021120 - R01 Software Page 27 of 48
C1-Public
NORA-W36 bootloader: 1.0.1-001
u-blox
> ?
?
Help
r <baud_rate> [ <flowctrl>]] Set baud rate and flow control on/off
q SoC reset
x Start Xmodem Rx
v Get version information
OK
> x
CCCCCCCCCCCCC
// Terminal sends the file using XMODEM protocol
OK
> q
+STARTUP
Figure 9: Software download using XMODEM
4.3 Wi-Fi MAC and Bluetooth device addresses and other
production data
NORA-W36 series modules are assigned a block of four MAC addresses. The first Wi-Fi MAC
address (base address) is encoded in the Data Matrix on the label. For data matrix details, see the
NORA-W36 datasheet
[2] and product labelling requirements for each region. See Regulatory
compliance .
MAC address Assignment AT command
Base address Wi-Fi station AT+USYLA=1
Base a 1 Wi-Fi access point AT+USYLA=2
Base a 2 Bluetooth Low Energy device address
AT+USYLA=0
Base a 3 Unused
Figure 10: MAC addresses
It is also possible to change Address by adding the address to the command, for example:
AT+USYLA=1,112233445566
The base MAC address and calibration data are written during the production of NORA-W3.