NORA-W36 series - System integration manual
UBX-22021120 - R01
Regulatory compliance
Page 39 of 48
C1-Public
The following statement must be included in the end-user manual or guide:
ISED end product labeling
The end product shall bear the following statement in both English and French in a conspicuous
location on the device:
Labels of end products capable of operating within the band 5150
–
5250 MHz shall also include:
For indoor use only
Pour usage intérieur seulement
When the device is so small or for such use that it is not practicable to place the statements above on
it, the information shall be placed in a prominent location in the instruction manual or pamphlet
supplied to the user or, alternatively, shall be placed on the container in which the device is marketed.
However, the FCC/ISED ID label must be displayed on the device as described above.
In cases where the final product will be installed in locations where the end-consumer is unable to see
the FCC/ISED ID and/or this statement, the FCC/ISED ID and the statement shall also be included in
the end-product manual.
6.5
Japan radio equipment compliance (pending)
☞
Use of 2.4 GHz channel 14 is supported for Japanese markets.
Contains FCC ID: XPYNORAW3
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications to this unit not
expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Contains transmitter module IC: 8595A-NORAW3
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence
-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
Contient le module émetteur IC: 8595A-NORAW3
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1.
L' appareil ne doit pas produire de brouillage;
2.
L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre lefonctionnement.
