SP/XX/IG/12/E/980228
C-1
C
If you have a problem . . .
This appendix describes things you can try if you have problems with your ScanPlus during
power-up, configuration and normal operation.
If you can not solve the problem yourself, please contact your UBI representative.
Before you contact your UBI representative . . .
Look in the following checklists if you have any of the following problems:
•
no
LEDs,
•
no
beeps,
•
error
beeps,
•
no transmission,
•
incorrect transmission.
Setup problems checklist
correct ScanPlus model
correct CMM / cables / external power supply
ScanPlus connected up correctly
system switched on—sufficient electrical power
correct power-up indication—2 beeps
number of green indicator LED flashes at power-up—correct
interface number selected for your ScanPlus model
End Selection scanned once or twice if required for certain
configuration codes
Summary of Contents for ScanPlus 1800
