SP/XX/IG/12/E/980228
4-1
4
Enter the interface number for your
host system
interface number
automatically configures your ScanPlus by setting interface-specific
parameters—in particular data transmission parameters—to suit your
operating environment
Using your ScanPlus
You are going to use your ScanPlus to read some of the configuration
bar codes provided in this Installation Guide.
The ScanPlus has special beeps for configuration bar codes:
•
two beeps indicate that the ScanPlus has successfully read the
configuration code and saved the setting,
•
six short beeps indicate a setup error (incorrect configuration code)
for the selected interface type.
If you have any problems reading the configuration codes, refer to Appendix C for help.
For full details on how to use your ScanPlus, see the user's leaflet for your ScanPlus
product if applicable.
Configuration codes with an asterisk (*) are factory default settings.
Summary of Contents for ScanPlus 1800
