UBI ScanPlus 1800, Installation Manual

Page: 62 / 80

7. Set up the operating parameters—Activate the pushbutton
SP/XX/IG/12/E/980228 7-2
Pushbutton models
By default, the pushbutton on ScanPlus pushbutton models is deactivated.
To activate the pushbutton, you must select the appropriate pushbutton activation code for
your ScanPlus model (standard or energy saver).
The ScanPlus does not flash in standby when the pushbutton is activated.
Standard pushbutton models
Standard pushbutton models are suitable for standard applications
where energy consumption is not a critical parameter.
When the ScanPlus goes into standby after one of the time-out
conditions has been satisfied, the reading light and read function are
switched off. Full energy is restored when the next reading situation
occurs.
ScanPlus ER/XP/PDF standard pushbutton models can be configured
to produce an aiming beam when in standby mode. The aiming beam is
a red light used to position the ScanPlus correctly over the bar codes
before reading is activated.
Energy saver pushbutton models
Energy saver pushbutton models are specially designed for energy-
critical applications—using the ScanPlus with laptop computers for
example.
When the ScanPlus goes into standby after one of the time-out
conditions has been satisfied, current consumption drops to zero until
the next reading situation occurs.
Activating energy saver pushbutton models deactivates the power-up
beeps and power-up LED—they can not be activated in Energy Saver
mode.