B. Does not pump water:
1.Check to see if the electric outlet has power.
2.Check to see if the cable is plugged into the power supply.
3.Check the fuse in the Power Supply - if necessary replace it.
4.Check the cable for possible cuts or damage.
C. Does Not Vacuum well or at all:
1.Check to see if the filter bag is clean.
2.Check to see if the intake valve flaps on the bottom of the
cleaner are free to allow entry of water and debris.
D. Does not cover the entire pool:
1.Check to see if the wheel movement is free of obstructions like
hair or accumulated debris.
2.Check to see if the filter bag is clean.
3.Adjust timing cycle so that the cleaner reaches the other side of
the pool.
E. Reverse Direction before reaching the opposite side wall of the pool.
1.
Adjust the transformer timer:
Up arrow will increase the number of seconds. You can choose
between
0
and
90
seconds
.
Repeat if necessary.
F. Waits too long at the wall site before reversing:
1.
Adjust the transformer timer:
Down arrow will decrease the number of seconds. You can choose
between
0
and
90
seconds
.
Repeat if necessary.
G. Floating cable and twisting cable care
1.Your new cleaner was designed to clean most above-ground
pools. Some pool shapes may cause the cable to coil or tangle
because the cleaner operates in a systematic circular pattern.
TROUBLE SHOOTING:
A. Does not reverse directions:
Take a garden hose and spray water into the valve housing at each
opening . The high water pressure should free the jet valve system of
any debris.
Remove one of the jet-outlets, taking out the two lateral screws (FIG.
19). Bend a common “giant” paper clip into a hook as shown in (FIG. 20)
Push the center Flap to open it and look into the Impeller. Typically, you
may find debris like hair, string, or a small twig caught in the impeller.
Use your paper clip to hook or free the debris and remove it (FIG. 21).
1.
2.
center flap
20
21
19
jet outlet
screw
In order to keep the filter bag from wrapping around the pump and blocking the
flow of water to the pump, please install the filter bag clips as shown.
8
Ubbink Manual Robotclean 1.indd 8
10.12.12 16:15
