Lock Pin
SETTING THE CLEANING PATTERN
ADJUSTING THE CLEANER
FOR YOUR POOL
The cleaner uses a systematic
cleaning pattern that allows the
cleaner to go back and fourth in
overlapping patterns. The cleaner
may be used to clean a variety of
different size pools, from the small, to
the very large. Before its first use, you
must set up the cleaner for your pool.
To adjust the cleaner you will use the
axle locking pin
. (Fig. 17). There are
two locking pins permanently
attached to the unit with a lanyard.
Only one locking pin is required for
most applications. For the very large
pools you will need to install an
additional locking pin (Located on the
jet valve housing). Follow the pin
configuration illustration for your size
pool (Fig. 18).
16
18
17
Your Jet cleaner is pre-set to scan and clean most pools from 70 feet ( 24 m) to 80 feet ( 27 m) in length. The Jet cleaner is factory set
to look like the picture in Fig.16 with one Lock pin installed on each side. The Jet cleaner will systematically clean your pool in a
consistent pattern.
After your Jet cleaner completes its cleaning cycle, remove the cleaner from the pool and transfer the lock-pins
from the right side of
the unit to the left side (vice-versa) Next time you use your Jet cleaner the cleaning unit will clean the pool in the opposite pattern.
This will ensure that your cleaner completely cleans your pool.
Lockpin in
preset position
Curves counter
clockwise in this
direction
Adjustable
axle
Fixed
axle
Goes straight
in this direction
Lockpin in
forward position
Curves on a
greater angle in
this direction
Adjustable
axle
Fixed
axle
Goes straight
in this direction
7
Ubbink Manual Robotclean 1.indd 7
10.12.12 16:15
