Filter bag maintenance
label
lock tab
side handle
wheel
tube
The cleaning cycle of the cleaner is two hours. After two hours of working, the cleaner will shut off automatically by an integrated timer inside
the unit. In some cases the pools are clean after less than 2 hours and sometimes two hours is not enough. The size and shape of the pool and
the amount of debris in it, will determine the total time of cleaning. When the cleaner slows down and constantly reverses directions before
reaching the end sides of the pool, it is sending a signal that it is time to clean or change the filter bag.
CLEAN THE FILTER BAG AFTER EVERY CLEANING CYCLE
a.
Unplug the power supply. (Please keep the plug away from contact with water)
b.
If the unit is in the pool, gently pull the cleaner toward you using the cable until the
handle is within reach. Use the side handle (not the cable) or the wheel tube (fig 9) to pull
the cleaner out of the pool after allowing most of the water to drain from the unit.
c.
Lay the unit on its back on a smooth surface (in order to prevent scratches on the
machine body), unlock and remove the bottom lid assembly. (fig.10,11,12,13)
d.
Remove the filter bag from the support bars (fig.14), turn it inside out and wash off all the
dirt with a garden hose or in a sink. Squeeze the bag gently until the rinse water is clear. If
necessary, machine wash the bag using only cold water with NO DETERGENT!
e.
Re-install the bag on the support bars with the
label
in the center of one of the long
sides of the bottom lid (fig. 15)
f.
Re-install the bottom lid assembly in the body. Push down on it until the lock tabs will
snap into place properly.
CLEANING CYCLE
6
Ubbink Manual Robotclean 1.indd 6
10.12.12 16:15
