UAZ CARGO, Operation Manual

Page: 58 / 208

58
Fig. 3.13. Key with remote
control panel:
1 — emission confirmation and
control panel battery discharge
indicator; 2 — lock unlocking and
alarm switching off button; 3 —
lock locking and alarm switching on
button; 4 — horn button
of the T/signals and interior lighting switching ON. If violations
of the security zone for the whole security period were detected
(Alarm actuated), a single horn will be given in addition to T/
signal blinking.
If after door unlocking and switching armed mode OFF none of
side doors or the T/gate are opened and the ignition is not started
up, in 30 seconds all doors will be automatically locked again and
the system will automatically switch over to the armed mode. The
possibility of automatically switching over to the armed mode
with door locking is indicated by frequent blinking of the system’s
signal device in the cluster .
Unlocking the door locks from the RCP
with side door window lowering
Unlocking of all side doors locks and the T/gate lock with
automatic side door window opening is carried out by pressing
the respective RCP button and holding it pressed till the window
starts moving (about 2–3 seconds). The system carries out opera-
tions specified in the above mentioned items to unlock door locks
and then carries out automatic moving of side door window to
open — firstly front windows, then back windows.
Every window movement is stopped automatically when reach-
ing the limit stop in the extreme position or all window movement
is stopped simultaneously by pressing any RCP button.
Movement of side door windows toward closing when locking
the door locks through the system is not to be carried out in order
to comply with the requirements of the international safety rules.