UAZ CARGO, Operation Manual, Page: 63 / 208

63
Fig. 3.15. Remote
control panel:
1 — screw;
2 — replace battery
Single pressing any button on the RCP when the system is in
alarm mode leads to interruption of alarm signal sending but the
system remains in armed mode. Armed mode is switched OFF
after button 2 on the RCP is pressed.
RCP battery replacement
A lithium battery, CR2032 type, is installed in the RCP, its
initial voltage is 3V. If the RCP’s supply voltage is within normal
range, indicator 1 flickers with every pressing of any button on
the control panel. If the indicator lights up with two short flickers
or does not light up at all when pressing any button, the battery
should be replaced.
For this purpose, unscrew screw 1 (Fig. 3.15) from the hous-
ing side, opposite to the control buttons; using a flat screwdriver,
separate the housing halves; pull the board out of the housing;
replace battery 2 observing connection polarity; insert the board
into the housing; clip the housing’s halves and tighten the screw.
RCP code re-synchronization
When the control panel’s buttons are pressed out of the radio
channel range, the floating code counter in the control panel falls
out of synchronization with respect to the counter in the system
control unit. If the number of control panel button pressings outside
the system reception signal range has exceeded 1,000, the system
stops responding to control panel commands. In this case the full
system teaching procedure should be carried out.