27
WARNINGS
1. During the initial operating period, all recommendations
specified in chapter “New motor vehicle running-in” shall be
strictly observed.
2. Switching on of the engine malfunction lamp does not mean
that the engine must be shutdown immediately. However, in case
of a malfunction caused by ignition failures (engine wobble or
jerking when driving the motor vehicle), the motor vehicle shall
be immediately (max. in 0.5 min.) stopped, and the engine shall
be shut off in order to prevent breakdown of catalytic converter.
3. Do not start driving motor vehicle with a cold engine. Avoid
high crankshaft speeds after starting a cold engine.
In order to prevent any difficulties when starting the engine,
follow the instructions in chapter “Engine start”.
4. In case of abnormal noises and knocks in a running engine,
find out the cause of their occurrence, the motor vehicle must not
be operated until the malfunction is corrected.
4.1. After starting a cold engine, the hydraulic valve may knock,
that should disappear in the course of engine warm-up to the
coolant temperature of 80–90 °С, but not more than in 30 minutes
after reaching the specified temperature. If knock persists, it is
necessary to check oil feed to the hydraulic pushers, or to replace
faulty hydraulic pushers.
5. For fail-safe operation, and to prevent accelerator pedal
breakdown, it is recommended to:
– not apply excessive loads on the pedal lever, after end of
operating stroke;
– avoid impact, lateral and other loads that do not correspond
to the pedal operating stroke.
6. Engage reverse in the gear box and down-shift in the transfer
case only when the motor vehicle completely stops.
7. Always shut-off the engine while fuelling the vehicle.
8. Before fuelling the motor vehicle, the heater-temperature
booster (if available) shall be switched off.
9. Do not overfill the fuel tank.
Summary of Contents for CARGO
Page 206: ...For Notes ...
Page 207: ...For Notes ...
