Tyco AutoPulse Z-10, Installation, Programming And Operating Instructions

Page: 33 / 89

3-1
This chapter describes connecting field wiring for all devices (smoke detectors, releasing
appliances, abort switches, etc.) to the AutoPulse Z-10, and wiring AC power to the panel.
Before installing any equipment, always make a survey of the area to be covered. Also, be sure to
follow the requirements of applicable codes and standards, as well as the directives of Authorities
Having Jurisdiction (AHJs).
Remove the plastic PCB cover as described in “Removing Plastic PCB Cover” in the previous
chapter.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Wiring Initiating Device Circuits 3-2
Wiring Releasing Circuits 3-5
Wiring Special Purpose Monitor Circuits 3-8
Wiring Relay Connections 3-11
Wiring Notification Appliance Circuits 3-12
Wiring AC Power and Battery Wiring 3-14
Wiring 24V Aux Power 3-17
Testing Circuit Supervision 3-18
Chapter 3
Connecting Field Wiring
and AC Power
Introduction
In this Chapter