Twilight MC-SUP2000H, Manual

Page: 50 / 69

Chapter 5 Data processing
- 45 -
output option is opened in the M50 menu, and secondly, the timing printing time is
set in the M51 menu.

Timing print options: in the M50 menu, set the timing print option to open (ON),
press ENT can enter the print option is set, in a total of 22 timing print content,
choose open (ON) option that is included in the printed content;Select OFF
content, will not print.

Setting: timing print time in M51 menu, press ENT to enter print time Settings,
print the unit too, minutes and seconds of time, you need to set up three
parameters: the start time, interval time and print.Start time setting: if starting
from the current time, press. Set hour, minute, second.If you need to start
printing from the set time, enter the start time.(Note that the input start time
must be after the current time, so when using this function, you need to check
the time in the M60 menu to avoid unsuccessful timing printing.)Interval time
setting: unit time, minutes, seconds, the minimum interval is best not less than
5 seconds, so as not to keep up with the printer.Printing times setting: 0~9999
times optional.Printing times reach the set number of times, the printer will
stop working.
5.3. Storage of measurement data
Ultrasonic flow meter (energy meter) data storage has two ways, the built-in 32Mbit
memory, before the use of data storage to do the following Settings: output data
flow control, timing output options, timing printing time Settings.
1. Output data flow control: if you need to output data to the built-in memory, select
the built-in recorder in M52, select Internal Bus in M52.(See table § 6.1)
2. Timed printout options: same as § 5.2
3.Timed print time setting: same as § 5.2
5.4. Analysis and statistics of measurement data
Exported stored data
The data recorded in the built-in 32Mbit memory can be exported to the computer
through the serial port using the M4A menu.