Tweco Spray Master Series, Safety And Operating Instructions Manual, Page: 7 / 36

SAFETY AND OPERATING INSTRUCTIONS
1 89200009
SECTION 1: INTRODUCTION
1.01 HOW TO USE THIS MANUAL
To ensure safe operation, read the entire manual, including the chapters on safety instructions and warnings.
Throughout this manual, the words DANGER, WARNING, CAUTION, and NOTE may appear. Pay particular attention
to the information provided under these headings. These special annotations are easily recognized as follows:
NOTE!
An operation, procedure, or background information which requires additional emphasis
or is helpful in efficient operation of the system.
!
CAUTION
A procedure which, if not properly followed, may cause damage to the equipment.
!
WARNING
A procedure which, if not properly followed, may cause injury to the operator or others in
the operating area.
WARNING
Gives information regarding possible
electrical
shock injury. Warnings will be enclosed in
a box such as this.
!
DANGER
Means immediate hazards which, if not avoided, will result in immediate, serious personal
injury or loss of life.
1.02 RECEIPT OF EQUIPMENT
When you receive the equipment, check it against the invoice to make sure it is complete and inspect the equipment
for possible damage due to shipping. If there is any damage, notify the carrier immediately to file a claim. Furnish
complete information concerning damage claims or shipping errors to the location in your area, listed on the back
cover of this manual. Include a full description of the parts in error.
If you want additional or replacement copies of this manual, please contact TWECO
®
at the address and phone
number in your area listed on the back cover of this manual. Include the Manual number (from page i).
1.03 DESCRIPTION
TWECO MIG Guns are furnished with rear connections to fit directly into most Miller
®
, Lincoln
®
, and Euro connection
wire feeders. These guns are referred to as Direct Plug MIG Guns. TWECO MIG guns are also furnished with the
time-proven MIG-Kwik connection. The MIG-Kwik connection, when utilized with a TWECO adapter kit, allows
a TWECO MIG gun to be installed on almost any wire feed system. For a listing of available adapter kits, see the
TWECO Adapter Kit Listing, Form No. TAKL-97, or call TWECO Customer Care.
Miller is registered trademark of Illinois Tool Works, Inc.. Lincoln is a registered trademark of Lincoln Electric Co. The aforementioned registered trademarks are no way affiliated with TWECO
products or ESAB. TWECO is a registered trademark of ESAB Group Inc.