Tweco Spray Master Series, Safety And Operating Instructions Manual, Page: 20 / 36

14
SAFETY AND OPERATING INSTRUCTIONS
89200009
SECTION 6: REPLACE CONDUCTOR TUBE
The conductor tube is attached to the Spray Master handle by two set screws on the side of the handle. To remove:
1. Loosen the conduit liner set screw with a 5/64" Allen wrench supplied and then loosen the socket head
cap screw securing the conductor tube in place inside the handle with a 5/32" Allen wrench. Refer to
the figure below.
2. Remove conductor tube.
3. With the front end consumables removed from the conductor tube. Slide the tube over the liner and
insert into the brass connection within the handle. Tighten the socket head cap screw wrench tight.
4. Tighten the conduit set screw down against the liner. Do not overtighten to avoid damages the liner.
Conduit liner set screw
Socket head cap screw