Tweco Spray Master Series, Safety And Operating Instructions Manual, Page: 18 / 36

12
SAFETY AND OPERATING INSTRUCTIONS
89200009
4.02 TWECO
®
MIG-KWIK CONNECTION AND ADAPTER KIT INSTALLATION
Installation of a TWECO MIG gun with a TWECO connector plug, may require an adapter kit. Choose the correct
adapter kit for your wire feeder from the Adapter Kit Listing. To install, follow the instructions furnished with the
adapter kit. Figure 4 shows the general adapter kit installation.
Receptacle
(TLAK-1 or 6TLAK-1)
Receptacle
(TAK-1 or 6TAK-1)
ADAPTER PLUG
WIRE FEEDER
GAS HOSE
GAS HOSE
POWER CABLE
CONTROL
WIRE
MIG GUN
Figure 4
1. Screw adapter plug into the receptacle and tighten.
2. Insert the adapter plug and receptacle into the wire feeder wire guideout. Tighten the wire guide
attachment screw.
3. If needed, attach a proper sized welding cable from the welding power source to the receptacle power
connection.
4. Attach a gas hose to the receptacle and to the feeder gas solenoid.
NOTE!
When using an adapter kit, the gas must be attached to the receptacle to provide gas to
the MIG gun. If the feeder gas supply is attached to the feeder wire guideout block, it must
be rerouted to the receptacle.
5. Insert the MIG gun rear connection plug into the receptacle and tighten the attachment screw.
6. Attach the control wire plug assembly to the wire feeder MIG gun control circuit. Then plug the flat
double female plug into the MIG gun.
The gun should now be installed and ready to feed wire as recommended by the feeder manufacturer.