The minimum value of 1 will fade the slowest, in about 2 seconds.
The default of 5 will take about 0.5 of a second.
The maximum value of 25 will fade almost instantly.
See the "Using Genlock, Overlay, and Mix" section for more information.
SC Phase
This value allows fine adjustment of th e subcarrier phase when genlocking, overlaying,
or mixing. This should never normally require alteration.
Press the + and - buttons to increase and decrease SC Phase.
The minimum and maximum values are -12 degrees and +12 degrees, and are
provided for fine-tuning of the overlaid signal's color phase.
Leave the value at 0 degrees if you at all unsure about changing it.
Other TV One products are available giving a full 360 degree adjustment.
See the "Using Genlock, Overlay, and Mix" section for more information.
Exit
To exit these adjustments press the + button when 'Exit...' is displayed.
Screen Size...
This al lows entry into a sub-menu (using + button), to set the SIZE and POS settings also
found on the infra-red remote control.
Out H-Center - altering the display's horizontal screen position
Pressing the + button will move the image to the right, pressing the - button will
move it to the left.
Adjust until the image is centered horizontally on the screen.
Out H-Width - altering the display's width
Press the + button to increase the width of the picture and - button to decrease it.
Adjust until the desired width of the image is obtained.
Out V-Center - altering the display's vertical screen position
Press the - button to move the picture up the screen and + button to move it down.
Adjust until the image is centered on the screen vertically.
Out V-Height - altering the display's height
Press the + button to increase the picture height and - button to decrease it.
Adjust until the desired height of the image is obtained.
If you wish to go back and chan ge an y of the above adjustments press the MENU button
until the desired adjustment is being displayed, then + or - to alter its setting.
24
B
o
th
v
er
si
o
n
s
