C2-1000 S
ERIES
O
PERATION
M
ANUAL
66
For use with dual-channel scalers such as the C2-7000 series, connect your video
source (e.g. a DVD player or computer) to an input on the C2-7000 unit. It is not
necessary to feed two signals – the C2-7000 unit can use the same signal for both
outputs.
For 2 single-channel scalers, you can either use a distribution amplifier so that a
single video source is split into 2 signals, or use the ‘loop’ output available on some
units.
12.5
Initial setup
This section describes how to start setting your scaler up. It is vital that your scaler
is ‘clean’ of any user settings, so it is advisable to perform a full factory reset by
either re-updating the firmware, or doing a factory reset (see earlier in manual for
how to do this).
Figures ‘a’, ‘b’ and ‘c’ show how an original wide-screen image is ‘split’ into two using
identical zoom values on Output 1 and Output 2. Zoom values for around 10% to
b
a
c
Showing setup of zoom for each channel.
