C2-1000 S
ERIES
O
PERATION
M
ANUAL
20
RGBS (separate sync at TTL levels)
YUV/YPbPr (including tri-level).
However, please note that on some units such as Down Converters, the RGB output
is there just to loop the PC image through to the PC monitor. On Video Scalers,
bypass mode (with the unit in Standby) will feed PC/HD in to PC/HD out directly.
YUV/YPbPr (component) outputs can also be switched to RGsB (sync on green)
mode if desired - see ‘Adjust outputs’ for more information.
CV and YC outputs always function simultaneously and can be set to either standard
NTSC or PAL – see ‘Adjust outputs’ for more information. Note that
RGB/YUV/YPbPr outputs also function in this mode.
If your unit has a UTP output, this output reflects whatever is at the PC/HD output,
but is encoded to be compatible with a Beacon UTP receiver over up to 300 meters
of UTP cable.
6.3
Audio inputs and outputs
Certain models (C2-1200, C2-1250, C2-1350) support audio switching, simultaneous
with video switching. This means that audio input 1 might switch at the same time as
RGB1, audio input 2 with YC1, etc. Each audio input connector can be configured to
be ‘linked’ to a particular video input connector, so that they switch together.
Once switched, the audio input connector is linked to the audio output connector with
no audio processing or buffering taking place. The only processing that is performed,
is ‘click-less’ operation.
On the back of audio-equipped units are 5 x 3-way connector blocks. These can be
removed individually (with care), or can be left in-situ whilst connections are made
(by releasing each terminal using a small screwdriver, and then by clamping it back
down again once a new cable has been inserted).
The diagram above shows the 5 connector blocks (as viewed from the rear of the
unit), each with Left, Ground and Right terminals.
