ACM 400 S motor control unit
9 / 24
Gate status
Reaction if “emergency stop” pressed
At a standstill, light is on
Light goes out (specific light shut-down)
opens / closes
Stop
in limit position “open“ or “closed“
-
Automatic closing mode
Menu
9“ – value:
00
Factory value:
01
keep open time completely restarts
Automatic closing mode disabled up to the
next command
Note:
This "emergency stop" function is merely a
command function
– it does
not
act as a
disconnecting device according to
DIN VDE 0100 Part 537
. If necessary you must
implement this facility on site!
h) Membrane keyboard
[X3.3], [X1], [X5]
If you use the version with the membrane keyboard integrated in the cover [X1], [X5],
connect it at the "Keyboard” slot on the printed circuit board [X3.3].
When connecting, ensure that the
ribbon cable is not twisted
. The gate can also be
controlled from this, as via the separate buttons at terminals 26...30. Emergency
operation (page
Fehler! Textmarke nicht definiert.
) is also possible via the
membrane keyboard.
i) Universal input
[X8.1]
With this you can realise both optional "partial opening mode" and "Automatic
closing".
"Partial opening mode”
enables only partial opening, e.g. as man lock. This is
achieved by limiting the opening time.
To do this connect a
button
(make contact element) to
terminals 23 / 24
[X8.1].
In
"automatic closing mode”
, automatic closing can be set via a time allowance.
To do this, connect a
switch
, e.g. a time switch, to
terminals 23 / 24
[X8.1].
If menu "A" is set to 00, then automatic closing is only active when the switch is
closed!
Menu
Value Function
“A”
00
Automatic closing mode
01
Partial opening function: opening time
…60
Limit of 01…60 sec.
Menu
Value Keep open time (automatic closing)
“5”
00
Automatic closing off
01
…82
In 2-second steps per digit
From 2…164 seconds
83
…95
In minute steps per digit from
3…15min, with 5 s warning time
If you have used a
radio receiver
(optional) (page 13), you can also use it to connect
the
universal input
(channel 4)
. This of course only makes sense if you have select
the
partial opening function
in menu
"A”
.
