ACM 400 S motor control unit
16 / 24
8) Programming
[X2]
This chapter describes how you can change the preset default values in the control
unit. Which values are available and what effect they have is described in chapter 5,
next to the respective possible connections.
a) Functions of the pushbuttons
[X2.2] Key "
"
value + / Menu + / Test and pulse function Open-Stop-Closed-
Stop-...
[X2.4] Key "
"
value - / Menu -
[X2.3] Key
"Menu"
menu management with 7 segment display
b) Start programming mode
For safety reasons the motor is locked in programming mode, as if Emergency
stop has been actuated.
Keep the
"Menu" key
pressed for longer than 1s, ...
until in the
left-hand display segment
the digit for the
Menu "0...L"
appears.
If you do
not press any key for longer than 15s or
press the
"Menu"
key for
longer than 1s
, the programming mode is switched
off
again.
c) Select menu / change value
You can use the arrow
keys
"
" to now select the menu "0...L".
If you now briefly press the
"Menu"
key, the value just set for this menu item
appears in the display.
You can now use the "
" keys to change the value, as described on pages
8...16.
The
value is immediately adopted
, as soon as you set it.
d) Reset
You can reset the values to the
factory default settings
, by pressing
both "
"
keys in “Function” mode
(approx 5s) until the two points in the display
stop
flashing
.
e) Change block
You can block the control panel on the printed circuit board so that the menu values
can only be read, however, it is not possible to change the values.
Menu "L"
, as described under a) and b).
Then
simultaneously
press both
"
" keys
and the
"Emergency stop"
button.
You can now use the
"Menu" key
to switch the value in
Menu "L"
between...
00
= free, changes possible
01
= blocked, page through menu only
This block feature is useful, e.g. during a phone diagnosis, in order to enable you to
read off the menus and notify the person at the other end without accidentally
changing anything.
f) Quit programming mode
If you do not press any key for longer than 15s or press the "Menu" key for longer
than 1s, programming mode is terminated. The values are already accepted, as soon
as you set them.
The factory default settings are given in the table from page 20.
