26
Operative Instructions
Ö
IMPORTANT NOTE! Open the door
immediately after the end of the program to
avoid condensation forming.
Check the results at the end of the cleaning process.
The instruments must be completely clean and dry.
Ö
IMPORTANT NOTE! Hollow instruments with
a small internal diameter must be dried
further with air.
- Check hollow instruments and retreat them if
necessary. The hole (lumen) of hollow instruments
must be free.
- The injectors must be correctly placed on the
connection tube in the cleaning chamber.
- The nozzles and connections to the base grid must
be firmly fixed.
If these checks are positive and the program has been
carried out without interruptions or malfunctions, the
load has been successfully cleaned and disinfected.
6.4.4 Extracting the load
At the end of the program and when extracting the
load:
- Do not force the door open to avoid damaging the
device or creating a hazardous condition.
a
WARNING! Particularly large instruments
can be very hot at the end of the program.
Allow instruments to cool down before
removing them. Use adequate gloves that
protects against burns.
a
WARNING! Failure to follow these
recommendations can cause burns.
7 Control Panel
1
2
3
4
8
7
6
5
Fig. 15
The control panel consists of 8 keys and a 3.5 inch LCD
display. All keys, except key "3", are multi-function,
depending on the action being performed in a specified
state of the device.
Here below the description of the control panel
standard (STD) and special (SPC) functions. Later on,
with the description of how the machine works, we will
find these symbols again.
Ö
IMPORTANT NOTE! "User Pin Management"
option on request. The special functions
(SPC) related to the username and password
settings for the USER are not available if the
option is not enable.
1) P1
STD: select program 1;
SPC: "1" character for the custom password;
SPC: navigate upward in the menu;
SPC: change the value of the highlighted
parameter.
2)
P2
STD: select program 2;
SPC: "2" character for the custom password;
SPC: navigate forward in the menu;
SPC: change the value of the highlighted
parameter.
3) P3
STD: select program 3;
SPC: "3" character for the custom password;
4) P+
STD: select the next program (proceeding by +1 at
a time upon program 40);
SPC: delete incorrectly typed field.
5) Door
STD: open the door at the end of the program;
SPC: exit from parameters and programs.
6) Prg
STD: enter to the program menu;
SPC: "C" character for the custom password.
Summary of Contents for TIVA8-MD
Page 56: ...56 Operative Instructions Notes...
Page 57: ...57 Operative Instructions Notes...
Page 58: ...58 Operative Instructions Notes...
Page 59: ...59 Operative Instructions...
