25
English
Program structure:
• Drain: It is used to empty the washing tank.
• Pre-wash: Pre-wash is necessary to eliminate coarse
dirt and foamy substances.
• Wash: Depending on the load, washing normally
takes place at 45°C - 65°C, adding the appropriate
detergent.
• Rinse: The rinsing operation eliminates and
neutralises the chemicals of previous washes.
• Disinfection: To prevent the load from being subject
to corrosion or patinas, purified water (if available)
should be used during the disinfection phase.
• Drying: Sufficient drying reduces the risk of corrosion
caused by the residual humidity on the load.
For programs details see Annex 9.3.
6.4 Starting the machine
After checking the integrity and full efficiency of the
machine, proceed with start-up.
1) Power the machine using the main circuit breaker.
2) Start the machine using the ON-OFF switch (1 Fig.
13) and open the door (key 5 Fig. 12) to introduce
the baskets.
6.4.1 Before starting the program
Before starting each program, check:
- Check that the filters, positioned on the bottom of
the tank (Fig. 9) are perfectly clean. Clean them, if
necessary.
- The nozzles of the upper and lower spray arms must
be free and clean.
- Basket and products must be arranged correctly.
- The spray arms must be able to rotate freely. The
machine constantly monitors the rotation speed
during the program.
- Liquid containers must be sufficiently filled. Check
for any messages on the display before starting the
program.
Closing the door
- Introduce the basket and load the instruments.
- Close the door and push it until the lock is activated.
The door can be unlocked and opened at any time
before the program starts, by pressing the key (5 Fig.
12).
Selecting the program
To select the programs available, use key 1, 2, 3 or the
key P+ (to select programs from 4 to 40)
on the control
panel (Fig. 12).
Choose the most suitable program depending on the
level of dirt on the products to be washed.
See chapter 6.3
6.4.2 Starting the program
a
WARNING. Always follow the indicated
procedures. Inattentive and superficial use
of electrical devices may lead to risks for the
operator.
The manufacturer is not liable for possible damage
caused by uncontrolled use of the device.
After selecting the program with relative key, the
display shows the selected program and the operating
time and temperature.
To start a program, press the START key (7 Fig. 12).
Program execution
Once the program has started, its progress can be
followed on the display. The display shows the program
phases during operations.
Pre-wash
Pre-wash is carried out with cold water (optional
softened water) and without liquids. It mechanically
dissolves encrusted organic materials and all proteins
on the surface of the instruments. Avoid too high water
temperatures.
Wash
It is the actual cleaning cycle. The cleaning tank heats
up until it reaches the specific temperature for the
selected program, a temperature that remains stable
for the holding time. The cleaning liquid is automatically
introduced before the start of the holding time.
Rinse
Rinsing is carried out with cold water, if the machine is
equipped with the second pump (optional) it is possible
to carry out the neutralisation cycle by introducing
neutralising liquid which is designed to reduce the
alkalinity and clean the instruments from residues
soluble in acid, e.g. limestone and rust.
Disinfection
Thermo-disinfection is carried out with deionised water,
depending on the setup of the machine, it is possible to
introduce the rinse aid to improve the drying phase.