83
Note
• This dive computer features a "Full Auto Light", so the auto light switch operates only when
available light is below a certain level. It does not illuminate the display under bright light.
• The auto light switch is always disabled, regardless of its on/off setting, when any one of
the following conditions exists.
●
While an alarm is sounding
●
While a bearing sensor calibration operation is being performed in the Digital Compass
Mode
●
An auto light switch operation is performed after a sensor reading
To Turn The Auto Light Switch On And Off
Turning on the auto light switch causes illumination to turn on,
whenever you position your wrist as described below in any mode.
Hold(+3 sec.)
Hold(+3 sec.)
t
t
A
M
L
P
t
LT
In the Time mode or Surface Mode, hold down
t
for at least 3
seconds to toggle the auto light switch on (LT displayed) and off
(OFF displayed).
• The auto light switch turns off automatically whenever battery
power drops to Level 4 (page 13).
• [LT] is displayed at upper right dot area for 2 seconds when auto
light switch becomes ON, and [OFF] is displayed for 2 seconds
when it becomes OFF.
• Since no icon of auto light switch ON/OFF is on the screen,
check ON/OFF by holding down
t
for 3 seconds.
