Charging a Lithium battery in normal CHARGE mode
The charger first charges with constant current(CC) according to the user setting then constant vohage(CV) when the
charging voltage reaches the peak point. In the
CV
phase the current gradually falls. The charger will terminate charging
when the curren1 falls below than 1/10 of the configured charge current.
R:03SER S:03SER
CONFIRM ENTER)
The left side of the first line set 1hc type of battery(LiPo, Lila or Lil;c). The value 011 the
left side of Sc..'Cond line sets the charge current and the value on the right side of second
line sets the cell count and voltage of the battery pack. After setting the current and
voltage, press
Stan/Enter
for more than 3 seconds to start the next process.
Charge current: 0.05 - JOA, Voltage: I •6 series(LiFe to 8 series)
The number of cells you set and the processor detects. lf 1he checking result is the same,
it would enter to the next interface; if not the same, the left side of the first line
'R: X X SER' shows the number of cells detected by the charger and the right side of the
first line 'S: X
X
SER' is the number of cells set by the user. Usually. the au10-de1ect
number won' t exceed the number set by the user. You should make sure that the
configured number and the actual number for the battery are the same and then you can
star! charging by
p
re
ss
i
ng
Start/Enter. If not, press Batt type/Stop to go back to the
previous screen and adjust the setting.
Lithium CHARGE mode. The screen shows the status during the charging process. You
can stop charging at any time by pressing
Batt type/Stop.
Press
Inc►
10 display each
cell' s voltage
(see
the balance voltage information) and press
◄
Dec
to display the
General Status information.
Fast charging a Lithium battery
The charger first charges with constant currem(CC) according to the user setting then constant voltage(CV) when the
charging voltage reaches the peak point. In the CV phase the current gradually falls. The charger will terminate charging
when the current falls below than I /5 of the configured charge current. This will result in slightly less than I 00% charge but
will complete sooner than the Normal charge mode.
R:03SER S:03SER
CONFIRM(ENTER)
The fast charging mode of Lithium battery. The left side of the first line set the type of
battery(LiPo, Lile or LiFe). The value on the left side of second line sets the charge
current and the value on 1he right side of second line sets the cell count and voltage of
the battery pack. After setting the current and voltage, press
Start/Enter
for more than 3
seconds to start the next process.
Charge current: 0.05 -JOA, Voltage: I -6 scries(LiFe to 8 series)
The number of cells you set and the processor detects. If the checking result is the same,
it would enter to the next interface: if not the same, the left side of the first line
'R: X X SER· shows the number of cells detected by the charger and the right side of the
first line 'S: X
X
SER' is the number of cells set by the user. Usually, the auto-detect
number won' 1 exceed the number set by the user. You should make sure that the
configured number and the actual number for the battery are the same and then you can
start charging by pressing Start/Enter. If not, press Batt type/Stop to go back to the
previous screen and ad
j
ust the setting.
Lithium FAST charging mode. The screen shows the status during the charging process.
You can stop charging at any time by pressing
Batt type/Stop.
Press
Inc►
to display each
cell' s voltage (see the balance voltage information) and press◄Dec to display the
General Status information.
II
