1.Go to the main menu, press the
Inc►
button
or
the
Stop/Batt type
button to go down, and press the
◄
Dec
button to go
up: press the Start/Enter button to enter a sub-menu.
2.ln a sub-menu, press
Start/Enter
to blink the chosen item, and then alter the value with
Inc►or
◄
Dec.With
nothing
blinking you can go to the sub-menu below with Inc► and above with
◄
Dec. Press Stop/Batt type to go back to the
previous screen
3.ln some sub-menu, press and hold Start/Enter for more than 3 seconds to start the process, such as starting charging or
discharging
4.During the charging/discharging
process you
can terminate the process at any time by pressing
Stop/Batt type
and
check
the attached information
with
Inc►
or◄ Dec.
Press Start/Enter to go back to the main information
screen
5.During the discharge process, press Start/Enter to alter the discharge current. When the discharge current blinks, press
Inc► to increase it or◄ Dec to decrease it, then press Start/Enter
to
confirm the change.
6.Press Stop/Batt type for more than 3 seconds to start the display of the active test information as per the following
diagram.
Present testing information:
In this display the output voltage is the idle voltage measured at the output tcrminals(that is, the voltage of the connected
battery pack).
Pressing Start for 3 seconds to monitor the resistance again.
Per cell resistance from
the ba
l
ance port.
Pack cells resistance from
the balance port.
Individual cell voltage from
the balance port
7.Rcsct to Defaults function. Press Stop/Batt type and Start/Enter together for more than 3 seconds to obtain this display:
Resume defaults?
CONFIRM (ENTER)
Press Start/Enter to reset all values to the system-default settings.
8.Adjust Current, Temp. Cut-Off, Safety timer, Capacity Cut-Off in course of charging and discharging.
Method of Application:
When in charging and discharging interface, press Start/Enter for 3 seconds, and current begins blinking.
Press Inc ►Or◄ Dec to adjust current, and press Start/Enter to save changes. If users press Stop/Batt type or without any
operation for I minute, it will cancel and quit from the changes.
Note:
Adjustment of current is only effective for charging and discharging, which will
not
saved as user setting.
When in charging and discharging interface,
press◄
Dec
for several times to see need-to-be changed information interface.
Press
Start/Enter
for 3 seconds, and the value begins blinking. The adjust method is as same as the above.
Note:
This change can be saved as user setting.
