Maintenance
To decrease the speed, turn the control linkage
clockwise in quarter turn increments.
7.
Retighten the jam nuts on the control linkage.
8.
Drive the machine and check the full forward
tracking.
9.
Replace the knee pad.
10.
Repeat steps through until desired tracking is
obtained.
Cleaning
Cleaning and Storing Safety
•
Park machine on level ground, disengage drives,
set parking brake, stop engine, and remove key.
Wait for all moving parts to stop before leaving
the operator’s position. Allow the machine to cool
before servicing, adjusting, fueling, unclogging,
cleaning, or storing.
•
Clean grass and debris from the muffler, drives,
and engine compartment to prevent fires.
•
Allow the machine to cool before storing the
machine in any enclosure. Do Not store the
machine or fuel container, or refuel, where there
is an open flame, spark, or pilot light such as on a
water heater or other appliance.
Clean Engine and Exhaust
System Area
Service Interval: Before each use or daily
(May be required more
often in dry or dirty
conditions.)
CAUTION
Excessive debris around engine cooling air
intake and exhaust system area can cause engine,
exhaust area, and hydraulic system to overheat
which can create a fire hazard.
Clean all debris from engine and exhaust system
area.
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Clean all debris from rotating engine air intake
screen, around engine shrouding, and exhaust
system area.
3.
Wipe up any excessive grease or oil around the
engine and exhaust system area.
4.
Clean muffler heat shields of all debris, dirt, and
oil.
Remove Engine Shrouds and
Clean Cooling Fins
Service Interval: Every 80 hours
52
Summary of Contents for Z-SPRAY JUNIOR Series
