turck FGEN-AIM Series, User Manual

Page: 84 / 203

Implementation of EtherNet/IP™
D301271 1013 - FGEN - multi protocol 7-30
Object Instance 2
Table 7-24:
Object Instance 2,
Gateway Instance
Attr. No.
dec.
(hex.)
Attribute name G et/
S et
Type Description
109
(6Dh) Status register 2 G STRUCT The Status Word contains general station
status information:
Station
– Bit 15: reserved
– Bit 14: "Force Mode Active Error" The Force
Mode is activated.
– Bit 13: reserved
– Bit 12: reserved
Internal bus
– Bit 11 "I/O Cfg Modified Error"
The configuration has been changed in an
incompatible way.
– Bit 10 "I/O Communication Lost Error"
Communication on the internal module bus
disturbed.
Voltage errors
– Bit 09 "U
sys
too low" System voltage too low
(< 18 VDC).
– Bit 08: reserved
– Bit 07: "U
L
too low" Load voltage too low (< 18
VDC).
– Bit 06: reserved
– Bit 05: reserved
– Bit 04: reserved
Warnings
– Bit 03: reserved
– Bit 02: reserved
– Bit 01: reserved
– Bit 00: "I/O Diags Active Warning" At least one
I/O-channel sends active diagnostics.
115
(73h) ON IO
CONNECTION
TIMEOUT G/S ENUM
USINT Reaction to the I/O connection exceeding the
time limit.
SWITCH IO FAULTED (0):
The modules are switched to Faulted State.
SWITCH IO OFF (1):
The gateway switches off the outputs of the
modules.
SWITCH IO HOLD (2):
No further changes to the I/O-data. The
outputs are held.
138
(0×8A) GW Status
register Get/
Set DWORD Allows to enable/disable the status register
which is part of the input data.
139
(0×8B) GW Control
Register Get/
Set DWORD Allows to enable/disable the control register
which is part of the output data.