TurboChef HIGH H BATCH 2, Service Manual

Page: 25 / 82

OVEN
MAINTENANCE
11
Step 6: Remove the Upper Jetplate
£
Remove both upper support rails by pulling the peg (Figure 6a).
£
Remove the upper jetplate. If additional clearance is required, remove the
air diverter using a Phillips screwdriver (Figure 6b).
£
Wash, rinse, sanitize, and dry the upper jetplate and support rails.
Step 7: Clean the Cook Chamber
CAUTION: DO NOT spray Oven Cleaner directly on the back
oven wall. Doing so may damage critical oven components,
resulting in a non-warranty service call.
£
Spray Oven Cleaner to break up stubborn stains and allow it to penetrate
for five minutes.
£
Scrub with a nylon scrub pad.
£
Clean the cook chamber thoroughly with a clean damp towel.
Step 8: Dry the Cook Chamber
£
Using a clean dry towel, thoroughly dry the cook chamber.
CAUTION: DO NOT operate the oven with water, cleaner, or
debris in the bottom of the cook chamber.
Step 9: Reinstall all Clean Parts
£
Reinstall in the following order:
1. Air diverter (if removed)
2. Upper jetplate
3. Upper support rails
4. Bottom jetplate
5. Lower support rails
6. Grease filter and bracket
7. Oven rack
Step 10: Apply Oven Guard
£
Follow instructions on the bottle.
Step 11: Clean the Cooling Fan Housing
£
Using a dry soft-bristle brush, clean the rear cooling fan housing.
Step 12: Wipe the Oven Exterior with a Clean Damp Towel
CAUTION: DO NOT spray chemicals into any openings, such as
the louvers on the side panels or the cooling fan openings on the
back of the oven. Doing so can damage critical oven components,
resulting in a non-warranty service call.
7
8
9
6b
6a
12
10
11