ATTENTION, flat side on the button to LEFT
It should now look like this.
The LEDs are not soldered in for the time being, as they will have to be adapted to the
housing later. For this purpose, the PCB is screwed to the front panel with the 10mm
spacers. The LEDs are now pushed through the holes in the front panel so that they are
flush with the front panel. The LEDs are soldered in this position.
Now the 4 jumpers are set and the voltages checked.
Jumper K7
switches the second MIDI socket (x3) either to MIDI out or through . to MIDI .
Currently Jeannie can only do MIDI through.
27
Summary of Contents for Jeannie
Page 7: ...Here is the front side of the board again Figure 5 Figure 6 7 ...
Page 8: ...And here is the back Figure 7 Figure 8 8 ...
Page 30: ...Here is the position of the AD converter Here is the position of the AD converter 30 ...
Page 31: ...This picture shows how the pin header of the DAC is soldered to the board 31 ...