Now it should look like this.
Please clean the solder joints and look over them again with a magnifying glass.
Figure 13
Once the SMD components are soldered, the most difficult part is done.
Now we turn the board over and solder the complete power supply.
We start with the TS 1117 3.3 Volt. This is the last SMD component.
TS 1117 33
3,3 Volt Regulator
SMT/SMD
11
Summary of Contents for Jeannie
Page 7: ...Here is the front side of the board again Figure 5 Figure 6 7 ...
Page 8: ...And here is the back Figure 7 Figure 8 8 ...
Page 30: ...Here is the position of the AD converter Here is the position of the AD converter 30 ...
Page 31: ...This picture shows how the pin header of the DAC is soldered to the board 31 ...
