Attention, 2 buttons (depending on availability) can be used for the sequencer. One push-
button without built-in LED or one push-button with built-in LED.
*** R35: if the LED and the push button are connected in parallel, R35 should be 150 ohm.
If no illuminated push button is used in the kit, please use R35= 220 ohm.
LEDs.
No, I have not forgotten them. The LEDs are installed at the very end. For this we
need the 4x 10mm spacers and the housing panel.
The LEDs are put on the positions. Then the panel is screwed on.
The LEDs are put through the holes in the panel so that they are flush with the surface and
then soldered on.
LED D3,4,5,7,8,10,
1N4001 D1
LED D3,4,5,7,8,10,
-through hole
polarized , short leg is (-)
minus
24
Summary of Contents for Jeannie
Page 7: ...Here is the front side of the board again Figure 5 Figure 6 7 ...
Page 8: ...And here is the back Figure 7 Figure 8 8 ...
Page 30: ...Here is the position of the AD converter Here is the position of the AD converter 30 ...
Page 31: ...This picture shows how the pin header of the DAC is soldered to the board 31 ...
