Now the display is installed
It is important that the display is approx. 9.5 mm high from the circuit board to the display
glass, otherwise it will not fit into the housing.
First, carefully remove the plastic holder of the pins. This has already been done with
displays from TubeOhm. Then the pins are shortened.
Now all the pins measured from the bottom are approx. 4..4.5 mm long. This is enough to
insert the display flush into the socket.
32
Summary of Contents for Jeannie
Page 7: ...Here is the front side of the board again Figure 5 Figure 6 7 ...
Page 8: ...And here is the back Figure 7 Figure 8 8 ...
Page 30: ...Here is the position of the AD converter Here is the position of the AD converter 30 ...
Page 31: ...This picture shows how the pin header of the DAC is soldered to the board 31 ...
