Attention,
the socket strip for the DAC is only 5mm high. The DAC is a little lower so that
the SD RAM card can be pulled out of the Teensy.
Now the bottom side is ready.
We solder the remaining components from above.
Please turn the board over again.
We need :
2x 12 pin header.
h=5mm
Cut it to 8 pin for the LCD
-through hole
LCD
header 8 pin /cut
R1,2,3,4=10k poti
-through hole
4x data pots
Encoder with switch
-through hole
1x data encoder
Volume poti
-through hole
red switch/mute-panic
Mute-panic switch
attention , polarized
flat side to left
SEQ Switch. Can be with or
without LED.
SEQ switch
attention , polarized
flat side to left
4 switches in black,unisono,
boost, shift , load/save
attention , polarized
flat side to left
K7 Header 1x3
Select MIDI through/out
Set the jumper first in
through mode.
26
Summary of Contents for Jeannie
Page 7: ...Here is the front side of the board again Figure 5 Figure 6 7 ...
Page 8: ...And here is the back Figure 7 Figure 8 8 ...
Page 30: ...Here is the position of the AD converter Here is the position of the AD converter 30 ...
Page 31: ...This picture shows how the pin header of the DAC is soldered to the board 31 ...
