Now we turn to R12,16,19,22,27,28,29,30,31,32,33,34,35,
As well as C2,5,6,43 to
Attention, R12,16,27,28,30,31,32 is the resistor matrix for the buttons.
Please make sure that the correct resistors are installed.
R12,16,22,27,28,30,31,
32,19,29
33,34,35
C2,5,6,43
R12,30 =10 kohm
-
brown,black,black,red,brown
-through hole
metalloxide , 1%
R28 =4,7 kohm
-yellow,purple,black,brown,brown
-through hole
metalloxide , 1%
R31= 22 kohm
-red,red,black,red,brown
-through hole
metalloxide , 1%
R32=47 kohm
-yellow,purple,black,red,brown
-through hole
metalloxide , 1%
R22,33,34,35=220 R
***R35 = 150R if SEQ-
Switch with LED
-red,red,black,black,brown
-through hole
metalloxide , 1%
R16=1 kOhm
-brown,black,black,brown,brown
-through hole
metalloxide , 1%
R27=2,2 kohm
-red,red,black,brown,brown
-through hole
metalloxide , 1%
R19,29=5,6 kohm
-green,blue,black,brown,brown
-through hole
metalloxide , 1%
C2,5,6,43=100nF
-marked 104
-through hole
X7R
23
Summary of Contents for Jeannie
Page 7: ...Here is the front side of the board again Figure 5 Figure 6 7 ...
Page 8: ...And here is the back Figure 7 Figure 8 8 ...
Page 30: ...Here is the position of the AD converter Here is the position of the AD converter 30 ...
Page 31: ...This picture shows how the pin header of the DAC is soldered to the board 31 ...
