background image

INSTRUCTIONS FOR MIDI INTERFACE

ROLAND JUPITER 8

    

USING THE MIDI INTERFACE

When you turn on the synthesizer for the first time, you will be in omni-on mode  for receive  (all channels)
and channel 1 for transmit  - See next page for factory default settings When you select  a transmit or
receive channel, this will be stored in memory and will be remembered  for when you subsequently  turn
on the synth - all parameters listed on the next page are stored.
If you want to put the machine back to the factory default settings at any time, switch  the  synth  on
whilst holding the red push button pressed - hold for a couple of seconds then release.

RED PUSH BUTTON

Three modes are available by pushing the red push button. Before you press the red button however,
make sure that no notes are pressed on the synth otherwise the results may be unpredictable.

1) PATCH CHANGE MODE

Pressing once only enters patch change mode. Any key then selects a patch change  which it sends
through MIDI. You are then automatically returned to playing mode.

2) SET-UP MODE

Setting MIDI channels and assignments. Give the red push button two short presses (half a second each)
- then release. Follow this with a note or sequence of notes as detailed on page 2. After  selecting  a
channel you will be automatically returned to playing mode but after making assignments you will need
to press the ENTER key (Top C) to return to playing mode. This is to enable you to  make  the  multiple  key
presses required when re-assigning sources to destinations. (N.B. set-ups are stored in non volatile
memory).

3) TRANSPOSE MODE

Press and hold the red push button for four seconds - then release. Middle  C will  sound on the  synth  and
continue to sound until you press a key. The note that you press will be the new middle C for MIDI IN.
You can set any value up to two octaves up  or down.  Settings  outside  this range will be ignored.  Note
that transpose mode cannot be entered from program mode.

ASSIGNING MIDI CONTROL SOURCES TO DESTINATIONS

SOURCES 

DESTINATIONS (d)=factory 

default

AFTERTOUCH 

off / modulation (d)/ p.bend / vcf / not used

CONTROLLER X 

off / vcf (d) / not used

CONTROLLER Y 

off / vcf / not used (d)

VELOCITY 

off (d) / vcf / vca

MIDI VOLUME 

off / vca (d)

Sources can control more than one destination at once, but a destination can only be controlled  by
one source at a time. Thus if velocity is currently controlling VCF and then  you  switch  aftertouch  to  VCF,
velocity will then control nothing until re-assigned.

Receive channel 

1 [ Bottom C ] MIDI note number 36

Db " 

2

D " 

3

Eb " 

4

E

"  " 

5

F " 

6

Reviews: