E600EN_01.DOC
Maintenance
17
6. Push the bolt pin (24) into the bore hole of the blade until it
reaches the stop.
7. Insert the locking washer (12) into the designated notch of the
bearing pin.
Turning or replacing the insertable cutters
3
26
7
24
10
F
F
F
F
4
12
8
3 Cutting
head
4 Insertable
cutter
7 Chip
separator
8 Handle
10 Fixing screws M 4x8
12 Locking
washer
24 Blade bearing pin
26 Blade
F
Lubricating grease "G1"
1. Unscrew the fixing screws (10).
2. Check the insertable cutters (4):
¾
When a cutting edge is blunt, turn the insertable cutter
by 180°.
Or
¾
When both sides of the cutting edges of an insertable
cutter are blunt, replace both insertable cutters.
3. Turn the handle (8) by a ¾ rotation to the right, in order to bring
the blade into the cutting position.
4. Push the chip separator (7) onto the cutting head until the chip
separator is positioned over the front edge of the blade.
5. Hold down the chip separator and insertable cutters in this
position.
6. Tighten the fixing screw (10).
7. Turn the handle (8) to the left to the working position.
Fig. 17577
