E600EN_01.DOC
Operation
11
4. Operation
Warning
Risk of injury due to improper handling!
¾
Make sure the machine is in a stable position when operating
it.
¾
Never touch the tool while the machine is running.
¾
Always move the machine during work away from your body.
¾
Do not operate the machine above your head.
4.1 Operating the TruTool C 160
1. Turn the safety lever (1).
2. Press the lever (2) against the motor housing.
1
2
1 Safety
lever
2 Lever
3. Guide the machine at an angle of about 15° to the sheet
surface.
Information
Do not move the machine towards the workpiece until full speed
has been reached.
To protect the machine and for a good cutting performance:
•
Ensure that blades are sharp.
•
Turn insertable cutters in due time.
•
Change insertable cutters in due time.
The following applies when cutting radii:
•
Do not tilt the machine.
•
Proceed with a low feed rate.
¾
Release the lever (2).
Switching on
Fig. 52384
Switching off
