Trotec TTR 50 E, Operating Manual

Page: 8 / 19

8 EN dehumidifier TTR 50 E
Operation
• After being switched on, the device operates fully
automatically – depending on the selected operating mode
or until the float indicates that the condensation tank is full
and the device switches itself off.
• Avoid open doors and windows.
Operating elements
10
13
14 15
16
17 18
19
20 21 22
23
24
25 26
27 28 29
11 12
9
No. Designation Meaning
9 Swing LED Illuminated when swing function is
activated
10 Swing button Switching the swing function on or off
11 Anion LED Illuminated when ionizer function is
activated
12 Anion button Switching the ionization function on and
off
13 60 % relative
humidity LED
Is illuminated when a relative humidity
level of 60 % is set
14 50 % relative
humidity LED
Is illuminated if a relative humidity of
50 % is set
15 Humidity button Switching continuous operation on or off
Setting the relative humidity level (50 %
or 60 % RH)
16 4 h timer LED Illuminated when the timer is activated:
4 h
17 2 h timer LED Illuminated when the timer is activated:
2 h
18 Timer button Switching the timer function on or off
19 Med LED Illuminated when a medium fan speed is
set
20 Low LED Illuminated when a low fan speed is set
21 Speed button Setting the fan speed
22 Run LED Is illuminated in green when the device
has been switched on
No. Designation Meaning
23 Full LED Is illuminated when the condensation
tank is full or not positioned properly.
24 On/off button Switching the device on or off
25 Power LED Is illuminated in red = standby or when
tilt protection has been triggered
26 High LED Illuminated when a high fan speed is set
27 8 h timer LED Illuminated when the timer is activated:
8 h
28 Continuous LED Is illuminated when continuous operation
is activated.
29 Humidity level
indication
Indication of the current room humidity
level
Switching the device on
Once you have completely installed the device as described in
the chapter Assembly and start-up, you can switch it on.
Note
Wait for 3 minutes before you switch the device back
on (e.g. after draining the condensation tank).
1. Use the On/Off button ( 24 ) to switch the device on.
ð
The Run LED ( 22 ) is illuminated.
Setting the operating mode
Ventilation mode
The device can be set to three fan speeds: low , med and high .
Low :
The device operates at low fan speed to save energy and keep
the operating noise to a minimum.
Med :
The device operates at normal fan speed.
High :
The device operates at high fan speed.
Select the fan speed as follows:
1. Press the Speed button ( 21 ) until the desired LED for the
fan speed is lit.