TrojanThree User Guide
Page | 65
Unscrew the cap
Overflow tube
•
To empty the waste ink bottle unscrew the cap and take ink tank to the place where the waste ink
can be disposed.
•
In case the waste ink bottle gets full of ink there is an overflow tube on top of the tank.
NOTE:
Keep a piece of cloth/paper towel/sponge nearby to avoid dropping of ink from tubing when
removing the cap of the bottle.
13.2
Replacing Micro Fiber Roller (MFR)
The wiper roller (microfiber roller) is a wear and tear part and needs to be replaced as it wears down.
It is advised to change the wiper roller in every 6 months.
Signs that the wiper roller might needs replacement:
•
If surface of the wiper roller looks shiny and not ‘fluffy’ anymore, then wiper roller is worn down
and needs replacement.
•
If printhead wiping routines (like wipe printhead or light/medium/heavy clean) do not improve
print quality and fine streak(s) remain on the printouts after the routines multiple times.
•
If ink puddles remain on the printhead surface after the wiper roller wiped.
Part number:
Part description:
10003356
T3 Wiper Roller Gen 2 (Micro Fiber Roller)
Required equipment:
WARNING!
The ink might be considered as Hazardous Waste in some countries. Make sure you fill
the waste ink from the bottle into a separated tank and disposal is done according to
the local regulations!
Material Safety Data Sheets (MSDS) for the Trojan ink can be downloaded from
Trojanlabel extranet.
Distilled Water
