Triumph Speed Triple 1200 RS, Owner'S Handbook Manual, Page: 40 / 184

General Information
40
Warning
After selecting a riding mode, operate
the motorcycle in an area free from
traffic to gain familiarity with the new
settings.
Do not loan your motorcycle to anyone
as they may change the riding mode
settings from the one you are familiar
with, causing loss of motorcycle
control and an accident.
Warning
If Traction Control (TC) has been
disabled in the Main Menu as
described on page 46 then all TC
settings that were saved for all riding
modes will be overridden.
TC will remain off regardless of the
riding mode selection, until it has been
re-enabled or the ignition has been
switched off then on again.
If the traction control is disabled,
the motorcycle will handle as normal
but without traction control. In this
situation accelerating too hard on
wet/slippery road surfaces may cause
the rear wheel to slip, and may result
in loss of motorcycle control and an
accident.
Note
The riding mode will default to ROAD
when the ignition is switched ON, if the
RIDER mode was active the last time the
ignition was switched OFF with TC set to
OFF in the required mode.
A warning message is shown stating
that the riding mode has changed. It
also briefly allows the riding mode to
be changed back to the original riding
mode.
Otherwise, the last selected riding mode
will be remembered and activated when
the ignition is switched ON.
If the mode icons are not shown when
the ignition switch is in the ON position,
make sure that the engine stop switch
is in the RUN position.
12:34
AM
15
c
o
0
0
F
E
N
MPH
RPM X 1000
2
4
3
5
6
7
8
9
10
1
2
4
3
5
6
7
8
9
10
1
m
Rain
ABS
Rain
MAP
Rain
TC
Rain
4 3
1
5 2
1. Mode button
2. Current riding mode
3. Riding mode selection tray
4. Current riding mode selected
5. Current riding mode selected settings
To select a riding mode:
• Press and release the MODE button
on the left hand switch housing to
activate the riding mode selection
tray.
• The currently active riding mode
icon is shown highlighted.