Triumph Daytona Moto2 765 2020, Owner'S Handbook Manual

Page: 103 / 163

Maintenance
103
Note
HD4X Hybrid OAT coolant, as supplied by
Triumph, is premixed and does not need
to be diluted prior to filling or topping up
the cooling system.
To protect the cooling system from
corrosion, the use of corrosion inhibitor
chemicals in the coolant is essential.
If coolant containing a corrosion
inhibitor is not used, the cooling system
will accumulate rust and scale in the
water jacket and radiator. This will block
the coolant passages, and considerably
reduce the efficiency of the cooling
system.
Coolant Level Inspection
Note
The coolant level should be checked
when the engine is cold (at room or
ambient temperature).
4
2
3
1
1. Right hand fairing
2. MAX mark
3. MIN mark
4. Expansion tank
To inspect the coolant level:
• Position the motorcycle on level
ground and in an upright position.
The expansion tank can be viewed
by looking between the front forks
from the front of the motorcycle.
• Check the coolant level in the
expansion tank. The coolant level
must be between the MAX and MIN
marks.
• If the coolant is below the minimum
level, the coolant level must be
adjusted.
Coolant Level Adjustment
Warning
Do not remove the expansion tank or
radiator pressure cap when the
engine is hot.
When the engine is hot, the coolant
inside the radiator will be hot and also
under pressure.
Contact with this hot, pressurised
coolant will cause scalds and skin
damage.
Caution
If hard water is used in the cooling
system,
it will cause scale
accumulation in the engine and
radiator and considerably reduce the
efficiency of the cooling system.
Reduced cooling system efficiency
may cause the engine to overheat and
suffer severe damage.
The coolant expansion tank is mounted
to the right hand side of the radiator
and is covered by the right hand fairing.