Changing Modem Modes (Responder/Transponder/Modem)
Micron Modem
0630-SOM-00001, Issue: 03
20
© Tritech International Ltd.
Note
If any other devices are set up on the computer they may also be listed, if this is
the case they should not interfere with this operation so should be left alone.
Confirm the settings and close the
Channel Setup
page.
Switch off the power supply to the MicronNav100 Hub, connect the Transponder/Responder
Main
port to
Port B
of the MicronNav100 Hub. Position a magnet against the body of the unit
as shown below and re-apply power to the system.
After a few seconds the unit should be visible in the
Seanet Setup
window (and displayed
as
MINIMODEM
). If not try repositioning the magnet slightly and power-cycling again.
The system is now ready for the conversion to take place and detailed steps are explained
in the following 2 sections.
A.1.2. Conversion to Transponder
The Responder unit can now be reconfigured to Transponder mode by clicking on the
Action
arrow button in the
MINIMODEM
row followed by
Setup
from the sub-menu to display
the
AM100 ModemCfgSetup
page.
