Configuration
Micron Modem
0630-SOM-00001, Issue: 03
16
© Tritech International Ltd.
modem to calculate the total transmission time, and hence the
intervening distance in metres. This is displayed as a range value
between the two modems.
Responder (png)
When selected on receipt of a
png<LF>
string, the receiving modem
responds with an acoustic CHIRP - used for diagnostics only.
Force 4 Mode
Forces Setup mode to be entered without using a magnet during
power-up operation.
Save Cfg
Saves the current set of settings to a configuration file.
Load Cfg
Loads a set of settings from a configuration file.
Baud Rates
Caution
The Hi Speed 57600 setting in Async 0 (Serial LAN
AUX 1) section must not be altered - the magnetic reset
does not reset the baud rates).
This button will load the
Comms Setup
dialog. The only field that
should be altered is indicated in Figure 5.5, “Comms Setup Dialog”.
Figure 5.5. Comms Setup Dialog
To change the setting
1. Select the required baud rate from the list in the field indicated in
Figure 5.5, “Comms Setup Dialog”.
2. Press
OK
on the
Comms Setup
dialog.
3. Press
OK
on the
AM100ModemCfgSetup
dialog and the changes
made will be programmed into the modem.
Note
Any parameters not listed above are not effective at present and should not be
selected or changed from the factory defaults.
Adjustment of these additional parameters may render the unit inoperable and
require it to be returned to
Tritech International Ltd
to be reset.
