Tripp Lite NGI-M08C4-L2, Owner'S Manual

Page: 59 / 313

59
Apply Click
Apply
to take effect the settings.
Refresh Click Refresh to begin configuring this screen afresh.
Port Status
Port
This field displays the port number.
State
This field displays whether the port is enabled or disabled.
Speed/Duplex This field displays the speed either
10M , 100M or 1000M and the duplex
mode Full or Half .
Flow Control
This field displays whether the port’s flow control is On or Off .
Link Status
This field displays the link status of the port. If the port is up, it displays the
port’s speed, duplex and flow control setting. Otherwise, it displays Link
Down if the port is disabled or not connected to any device.
5.4.2. Information
5.4.2.1. CLI Configuration
Node Command Description
enable show interface IFNAME This command displays the current port
configurations.
enable configure terminal This command changes the node to
configure node.
configure interface IFNAME This command enters the interface
configure node.
interface show This command displays the current port
configurations.
interface description STRING This command configures a description
for the specific port. The length of
description is up to 240 characters.
interface no description This command configures the default
port description.
interface alias STRING This command configures an alias for
the specific port. The length of alias is
up to 64 characters.
interface no alias This command reset the alias to default.
configure interface range
gigabitethernet1/0/PORTLISTS
This command enters the if-range
configure node.
if-range description STRINGs This command configures a description
for the specific ports.
if-range no description This command configures the default
port description for the specific ports.
if-range alias STRING This command configures an alias for
the specific ports. The length of alias is
up to 64 characters.
if-range no alias This command reset the alias to default.