21
The NGI-M08C4-L2 has a DIN rail bracket on the back of the Switch.
Location:
The NGI-M08C4-L2 can be DIN-Rail-mounted in cabinet or enclosure.
Mounting the Switch
Place the NGI-M08C4-L2 on the DIN rail from above using the slot. Push the front of the switch
toward the mounting surface until it snaps into place with a click sound.
Dismounting the Switch
Pull out the lower edge of the switch and then remove the switch from the DIN rail.
Ground the Switch
Before powering on the switch, ground the switch to earth.
Ensure the rack on which the switch is to be mounted is properly grounded and incompliance
with ETSI ETS 300 253. Verify that there is a good electrical connection to the grounding point
on the rack (no paint or isolating surface treatment).
ATTENTION
This product is intended to be mounted to a well-grounded mounting surface such as
a metal panel.
CAUTION
The earth connection must not be removed unless all power supply connection has
been disconnected.
The device is installed in a restricted-access location it has a separate protective
earthing terminal on the chassis that must be permanently connected to earth ground
to adequately ground the chassis and protect the operator from electrical hazards.
Summary of Contents for NGI-M08C4-L2
Page 1: ......
Page 285: ...285 9 2 2 Web Configurations...
