Tripp Lite NGI-M08C4-L2, Owner'S Manual

Page: 132 / 313

132
6.3.7.3 Selective Q-in-Q
6.3.7.3.1 CLI Configuration
Node Command Description
enable show vlan-stacking selective-
qinq
This command displays the selective Q-in-Q
configurations.
enable configure terminal This command changes the node to configure
node.
configure vlan-stacking (disable|port-
based|selective)
This command disables the vlan stacking or
enables the vlan-stacking with port-based or
selective on the switch.
configure vlan-stacking selective-qinq
STRINGS
This command creates a selective Q-in-Q profile
with the name.
configure no vlan-stacking selective-
qinq STRINGS
This command removes the selective Q-in-Q
profile with the name.
qinq active This command enables the selective Q-in-Q
profile.
qinq inactive This command disables the selective Q-in-Q
profile.
qinq cvid <1-4094> This command specifies the customer’s VLAN
range on the incoming packets.
qinq spvid <1-4094> This command sets the service provider’s VLAN
ID for outgoing packets in selective Q-in-Q.
qinq priority <0-7> This command sets priority in selective Q-in-Q.
qinq access-ports PORTLISTS This command specifies the access ports to apply
the rule.
qinq tunnel-ports PORTLISTS This command specifies the tunnel ports to apply
the rule.
qinq end The command exits the CLI Q-in-Q node and
enters the CLI enable node.
qinq exit The command exits the CLI Q-in-Q node and
enter the CLI configure node.
qinq show The command shows the current selective Q-in-
Q profile configurations.