Page 67
E Series Ethernet Radio – User Manual
Version 08-10
EH45e
Radio
Frequency Range:
380-520 MHz
(various sub-frequency
bands available)
Frequency Splits:
Various Tx/Rx
frequency splits - programmable
Channel Selection:
Dual synthesizer,
6.25 kHz channel step
Channel Spacing:
12.5 or 25 kHz
Frequency Accuracy:
±1ppm
(-30 to 60°C) (-22 to 140F) ambient
Aging:
<= 1ppm/annum
Operational Modes:
Full duplex
(optional internal or external duplexer
available for single and dual
antenna operation)
Configuration:
All configuration via
Windows based software
Compliances:
ETSI EN300 113, EN301 489, EN60950
FCC PART 15, PART 90
IC RS119, ICES-001
ACA AS4295-1995 (Data)
Transmitter
Tx Power:
1W to 5W
(+30dBm to 37dBm) ±1 dB
or
5W to 20W
(+37dBm to 43dBm ) ±1 dB
User configurable with
over-temperature and reverse
power protection
Modulation:
User configurable
narrow band digitally filtered binary
GMSK or 4 Level FSK
Tx Spurious:
<= -37 dBm
Tx Control:
Auto (on Data) / RTS line
(Serial Port) / System Port Override
Receiver
Sensitivity:
-118 dBm for 12 dB SINAD
Selectivity:
Better than 60 dB
Intermodulation:
Better than 70 dB
Spurious Response:
Better than 70 dB
AFC Tracking:
Digital receiver
frequency tracking
Mute:
Programmable digital mute
Diagnostics
Network wide operation from any
remote terminal.
Non intrusive protocol - runs
simultaneously with the application.
Over-the-air re-configuration of all
parameters.
Storage of data error and channel
occupancy statistics.
In-built Error Rate testing capabilities.
Connections
Serial Port:
1 x DB9 female DCE
300 - 38,400bps
Ethernet Port:
10/100 MBps (auto
MDIX sensing) 802.3 compliant
System Port:
RJ45 (front and rear)
for diagnostics, configuration
and programming
Antenna:
2 x N female bulkhead
(separate Tx
and Rx ports) 1 x N female bulkhead
(with optional internal duplexer)
Power:
2 pin locking, mating
connector(s) supplied
LED Display:
Multimode Indicators for
Pwr, Tx, Rx, Sync, TxD and RxD data
LEDs (for both port A and B)
Security
Encryption:
128-bit AES encryption*
Authentication
: Optional Trusted radio
authentication using Radius
compliant server
General
Power Supply:
13.8 Vdc
nominal (11-16 Vdc)
Operating Temp:
-30degC to +60degC
Transmit Current:
5W Version:
2.0 A Nom @ 1 W
3.2 A Nom @ 5 W
Receive Current:
< 1 A
Dimensions (5W/20W):
5W:
19” 2 RU rack mount 485 x 90 x
420/446 mm (Including heatsink) 19 x
3.5 x 16.5 /17.5 inches
Weight:
12.7 kg (28Ibs) (excluding
optional duplexer)
Ethernet
Protocols
: Ethernet/IP (including UDP,
TCP, DHCP, ARP, ICMP, STP, IGMP,
SNTP & TFPT)
Terminal Server:
Legacy RS-232 serial
support via embedded terminal server
(UDP/TCP).
DHCP Modes:
Auto and Manual
Telnet:
Telnet access to programming
and diagnostics interface.
SNMP:
SNMP V1/V2 access to
diagnostics and radio information
Modem
RF Channel Data Rate:
4800/9600/19,200 bps Full duplex
Data Buffer:
16 kbyte of on-board RAM
Bit Error Rate:
< 1x10-6 @ -110 dBm (4800 bps)
< 1x10-6 @ -108 dBm (9600 bps)
< 1x10-6 @ -106 dBm (19,200 bps)
Collision Avoidance:
TRIO Datacom’s
unique supervisory Channelshare™
collision avoidance system
Multistream™:
TRIO Datacom’s
unique simultaneous delivery of
multiple data streams (protocols)
Firmware:
Field upgradable
Flash memory
Hot Standby Controller (HSC)
Features: Alarm indications, manual /
auto change-over control, continuous
monitoring of Tx power, RSSI,
frequency offset, recovered data,
power supply, and diagnostic
commands from each base.
Options
Internal / External Duplexers, Band
Reject and Band Pass
TVIEW+™
Configuration, Network
Management and Diagnostic Software
Local regulatory conditions may determine the
performance and suitability of individual versions
in different countries. It is the responsibility of
the buyer to confirm these regulatory conditions.
Performance data indicates typical values related
to the described unit.
Information subject to change without notice.
© Copyright 2009 TRIO Datacom Pty Ltd.
All rights reserved. Issue 07-2010
• Export restrictions may apply
Note: Not all product features are available
in every mode of operation.
