Page 4
E Series Ethernet Radio – User Manual
Site Earthing
Ensure that the chassis mounting plate, power supply (-) earth,
RTU terminal device, and lightning arrester, are all securely
connected to the earth in the building installation or a common
ground point to which an earth stake is attached. When installing
EB/EH45e units, please pay particular attention to 24Vdc PLC
systems using DC-DC converters to supply 13.8Vdc
R&TTE Notice (Europe)
Applies to models Ex45e-xx
E
xx-xxx
In order to comply with the R&TTE (Radio & Telecommunications
Terminal Equipment) directive 1999/5/EC Article 3 (Low Voltage
Directive 73/23/EEC), all radio modem installations must include an
external in-line lightning arrestor or equivalent device that complies
with the following specifications:
•
DC Blocking Capability - 1.5kV impulse (Rise Time 10mS,
Fall Time 700mS) (Repetition 10 Times) or 1.0kV rms 50Hz
sine wave for 1 minute.
TRIO Datacom declares that the E Series Ethernet radio modem
range are in compliance with the essential requirements and other
relevant provisions of the Directive 1999/5/EC. Therefore TRIO
Datacom E Series Ethernet equipment is labelled with the following
CE-marking.
0889
Co-Locating the ER45e remote (Europe)
The ER45E is a remote radio and should not be co-located with
other transmitting equipment.
Part A - Preface
Compliance Information
Warning - RF Exposure
The radio equipment described in this user manual emits low level
radio frequency energy. The concentrated energy may pose a
health hazard depending on the type of antenna used.
To satisfy EU and FCC requirements a minimum separation
distance should be maintained between the antenna of this device
and persons during operation as per the table below.
FCC Notice (Hot Standby Controller Only)
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction, equipment may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
•
Re-orient to relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit different to
that which the receiver is connected.
•
Consult the dealer or an experienced radio/television
technician for assistance.
IC Notice (Hot Standby Controller Only)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appariel numerique de la class B est conforme a la norme
NBM-003 du Canada.
Safety
Warning: Where an ER45e is to be operated between 45°C and
60°C ambient, it must be installed in a restricted access location.
Warning: Where an EB45e is to be operated between 50ºC and
60ºC, it must be installed in a restricted access location.
