Trinity Highway QuadGuard M Wide, Product Description Assembly Manual

Page: 29 / 64

TrinityHighway.com 28 Revision D March 2021
Note:
Starting at the Backup, attach left and right Fender Panels shown below in Step(s) 4 & 5
with each tapered end pointing toward the rear of the system.
Step 1
Place the Fender Panel so that the center of the slot of the backup Hinge Plate is lined up
with the approximate center of the slot in the Fender Panel.
Attach Mushroom Washer Assembly as shown i n Figure 28, De tail A, and B. Do not tighten
fasteners at this time. This first step helps balance the Fender Panel.
Step 2
Slide the Fender Panel forward until the holes in the Fender Panel line up with the holes
in the forward Diaphragm Hinge Plate.
Step 3
Use a drift pin to align the center hole of the Fender Panel with the center hole of the
Diaphragm Hinge Plate.
Step 4
Attach the front of the Fender Panels to the next Diaphragm Hinge Plate using two (2) rail
bolts and large hex nuts per side. Use only the top and bottom holes and leave the center
hole open until the next Fender Panel is attached.
Figure 28
Wide Fender Panel Assembly
5/8 HEX NUT (SMALL)
LAST DIAPHRAGM
6” DIE SPRING
5/8 RAIL NUT (LARGE)
BACKUP
MUSHROOM WASHER
5/8 X 8 1/2, G8
FLATHEAD SOCKET SCREW
FENDER PANEL
5/8 LOCK WASHER
5/8X4 G5 HEX BOLT